"Ferrite Beads Installation
on Cell Phone Headset Instructions Page"

Step 1

Open Ferrite Bead and disconnect your headset wire from your cell phone as shown in the figure to the left..

Step 2

Loop headset wire around itself one time, creating a loop large enough to fit over the length of the Ferrite Bead.

Be sure to make the loop close to the end of the wire that plugs into your cell phone.

Place looped section of headset wire over one side of the Ferrite Bead.

Be sure to have the section where the looped wire crosses itself against the inside surface of the Ferrite Bead.

Lengthen this crossed section so that each side of the loop, touching the inside of the Ferrite Bead, spans the entire length of the Ferrite Bead.

Step 4

Close the Ferrite Bead securely and plug the headset wire back into your phone.

Step 5

Once the headset wire is properly in place, pull either end so the wire fits snuggly around the Ferrite Bead.